Superlite C, C/P, Superceram & Pyran™ Platinum (5mm thick Glazing)
|
| Rating: |
Application: |
Max Area: |
Max W: |
Max H: |
Stop H: |
| 20-90 Minute |
Sidelites, Fire Windows, & Transom in Steel frames |
3323 |
77-3/4 |
77-3/4 |
5/8 |
* Assemblies must be rated per application.
Superlite C/S, C/SP, Superceram F & Pyran™ Platinum F (5mm thick Glazing)
|
| Rating: |
Application: |
Max Area: |
Max W: |
Max H: |
Stop H: |
| 20-90 Minute |
Sidelites, Fire Windows, & Transom in Steel frames |
3323 |
77-3/4 |
77-3/4 |
5/8 |
| 20-90 Minute |
Wood/Wood Composite or Steel Doors (non-temp rise) |
2799 |
36 |
77-3/4 |
5/8 |
| Up to180 Minute |
Wood/Wood Composite or Steel Doors (non-temp & temp rise) |
100 |
10 |
33 |
5/8 |
* Assemblies must be rated per application.
(S) = Safety Film
(F) = Safety Film
Pyran™ Platinum L (9mm thick)
|
| Rating: |
Application: |
Max Area: |
Max W: |
Max H: |
Stop H: |
| 20-90 Minute |
Sidelites, Fire Windows, & Transom in Steel frames |
3143 |
75 |
75 |
1/2 |
| 20-90 Minute |
Wood/Wood Composite or Steel Doors (non-temp rise) |
2736 |
36 |
75 |
5/8 |
| Up to180 Minute |
Wood/Wood Composite or Steel Doors (non-temp & temp rise) |
100 |
12 |
33 |
5/8 |
- Assemblies must be rated per application.
Listed products are intended to be installed, unless otherwise noted, in accordance with the following:
NFPA-80, Fire Doors & Windows
Manufacturer's Instructions.
Listed maximum sizes of glazing are based on sizes tested and may exceed those allowed by local codes. Dependent on the end use installation, local codes may require that additional criteria be met to address considerations such as radiant heat hazards and impact safety. Under such circumstances, the prior approval of the Authority Having Jurisdiction must be obtained unless conformance to relevant additional requirements is indicated within the individual listing.
Clearance between the edges if the glazing and the inside edge of the frame shall not exceed 1/8" unless otherwise noted in the individual listing or the manufacturer’s installation instructions.
All glazing is identified by an etched mark or label bearing the WHI Certification Mark or ETL Mark.
