PRODUCT DESCRIPTION
| Product |
Pellet Fuel Room Heater |
| Brand Name |
Cleveland Iron Works |
| Description |
The model PS20W Pellet Fuel Room Heater is constructed of carbon steel with a cast iron firebox access door. The outer dimensions are 20-inches deep, 28.5-inches high, and 18.25-inches wide. The heat exchanger is located directly above the firebox with outlet air grille positioned on the top front of the unit. A galvanized steel fuel hopper located on the rear of the unit. |
| Models |
Cleveland Iron Works models: PS20W, PS20WTS
Master Forge model: H30XL
Enerco models: C30XL, J30XL, N30XL, C20W, H20W, J20W, N20W, C20WTS, H20WTS, J20WTS, N20WTS |
| Model Similarity |
Models PS20WTS, C20WTS, H20WTS, J20WTS, and N20WTS are identical to model PS20W, but these models use a touch screen display for the controller.
PS20W to the C30XL, H30XL, J30XL and N30XL includes an overall increase in height of 130 mm, which includes louvers above the viewing door. The hopper dimensions were increased by 129.8 mm in height and 68 mm in depth at the top of the hopper.
Models C20W, H20W, J20W, N20W are all identical to model PS20W. |
| Ratings |
120V, 3.3A, 60Hz
Emissions – 1.70 g/hr |
CLEARANCES TO COMBUSTIBLE CONSTRUCTION
| CLEARANCES |
| Backwall to unit |
1.5-in/38 mm |
| Sidewall to unit |
5-in/127 mm |
| Backwall to connector |
3-in/77 mm |
FLOOR PROTECTION REQUIREMENTS
Unit is acceptable for use on a combustible surface. A non-combustible protective cover must be placed a minimum of 6-inches (18-in for Canada) from the front and 6-inches beyond both sides for the fueling door. Floor protection must extend 2-inches beyond each side of a horizontal chimney connector.
