DeanSteel DSBR 3 Hour EPS Core Fire Door, Hollow Metal Type (12 gauge face) (Paper Honeycomb Core, or Polystyrene)
CATEGORY A DOORS - NO ADDITIONAL EDGE-SEALING SYSTEM REQUIRED
Hardware Limitations: Cylindrical / Cylindrical with Deadbolt / Mortise / Card Reader / Rim-Type Surface Mounted Fire Exit Devices / Surface Mounted Door Bottoms / Surface Mounted Closers/ Viewer / 16" Protection Plates.
Temperature Rise - Greater than 650°F at 30 minutes.
Configuration Maximum Size
Single 3'-0" wide x 7'-6" high
Standard Pair Not Allowed
Double Egress
Not Allowed
The product noted above has been tested and qualified per UL 10B, UL 10C, NFPA 252, and CAN / ULC S104 for up to a 3 Hour Positive Pressure Fire Rating.
These doors are eligible for use in any "Category C - Standard" frame. These doors may also be installed in frames listed in "Category C - Proprietary" in the accordance with the frame manufacturer's individual listing.
The door noted above is eligible to bear the "S" (for Smoke & Draft Control assemblies) if a listed "Category H - Smoke & Draft Control Gasket" has been applied to the assembly. Please refer to Category H for individual gasket manufacturer's listings.
Evaluated to the following...
Unless otherwise noted, assemblies in this section have been evaluated for conformance to the following standards:
CAN/ULC-S104, Standard Method for Fire Tests of Door Assemblies
NFPA-252, Standard Methods for Fire Tests of Door Assemblies
UL-10(c), Fire Tests of Swinging Door Assemblies
UL-10b, Standard for Fire Tests of Door Assemblies
and are installed in accordance with the following:
NFPA-80, Fire Doors and Windows
Manufacturer's Instructions
All assemblies are identified by a label or marking bearing the wording, "Listed (Product)", a time interval, temperature rise (if applicable), a serial number and the Intertek WH Certification Mark.
Unless otherwise specified, the Fire Doors referenced above have a minimum thickness of 1-3/4".
